Heat Recovery Steam Generator (HRSG) Learning Center

Heat Recovery Steam Generator (HRSG) Design


This introduction to HRSG Design is presented to provide an overview of the considerations and methods used in the thermal and mechanical design of watertube HRSG units as found in Cogeneration Plants, Combined Cycles, and the Refining & Petrochemical Industries.

The formulas and correlations presented herein are all in the public domain and are to be used only as a learning tool. Note that any product, process, or technology in this document may be the subject of other intellectual property rights reserved by sponsors or contributors to this site.

This publication is provided as is, without any warranty of any kind, either expressed or implied, including, but not limited to, the implied warranties of fitness for a particular purpose, or non-infringement.

The formulas, correlations, and methods presented herein should not be considered as being recommended by or used by the sponsors of this site. The purpose of this site is educational and the methods may or may not be suitable for actual design of equipment. Only an HRSG design engineer is qualified to decide if a calculation or procedure is correct for an application.

Click one of the following links to begin:
Scope
Types
Schematics
Heat Balance
Heat Transfer
Process
Circulation
Other

Disclaimer:

The formulas and correlations presented herein are all in the public domain and are to be used only as a learning tool. Note that any product, process, or technology in this document may be the subject of other intellectual property rights reserved by sponsors or contributors to this site. This publication is provided as is, without any warranty of any kind, either expressed or implied, including, but not limited to, the implied warranties of fitness for a particular purpose, or non-infringement.

The formulas, correlations, and methods presented herein should not be considered as being recommended by or used by the sponsors of this site. The purpose of this site is educational and the methods may or may not be suitable for actual design of equipment. Only a fired heater design engineer is qualified to decide if a calculation or procedure is correct for an application.